1. Core - Fire Core
2. Lock reinforcing plate
3. Closer reinforcing plate
4. Hinge reinforcing plate
5. Plywood faced - options are:
   1. MDF Face
   2. Steel Face
   3. Decorative Veneer
   4. Bolection Mould
   5. Steel sheet with channel surrounds
6. Timber edge strip

Standard Doors Supplied

• Doors must be stored or hung in dry buildings.
• Doors must be stored laying down on pallets (not standing or leaning against walls).
• A maximum of 2.5mm may be trimmed off the edge strips of the doors (=5mm off height and 5mm off width).
• The door frame must be built in ‘True Sqaure’ without wind for correct door installation.
• The fire door supplied to suit this frame (once fitted) must have a maximum of 10mm clearance between the underside of the door and finished floor and a maximum of 3mm between the sides and top of the door and the frame.
• Variations in colour, grain or texture are natural variations of timber. These variations are not to be considered a defect of the PLY or MDF.
• The entire door, including the top and bottom rails must be painted after fitting and before hanging. This requires 2 x coats of sealer or oil based primer. We recommend semi gloss paint be used for the top or finishing coat.
• TDF will not be held responsible if doors become defective because of failure to follow the directions outlined above.
• All doors are supplied as blanks and do not include hardware, installation or tagging. Blank tags and a Certificate of Compliance can be supplied when a ‘Compliance Details Check List’ has been completed, signed and returned to TDF.